Administrator Guide

ip http source-interface
Configure an interface’s IP address as the source IP address for HTTP connections.
C9000 Series
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number information:
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16383.
● For a Port Channel interface, enter the keyword port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
8.3.11.1 Introduced on the Z9000
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
8.1.1.0 Introduced on E-Series ExaScale
7.6.1.0 Support added for S-Series
7.5.1.0 Introduced on C-Series
ip telnet server enable
Enable the Telnet server on the switch.
C9000 Series
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Control and Monitoring 83