Administrator Guide

Level 1 or Level 2 routing. The range is from 0 to 16777215 irrespective of the
metric style. The default is 10.
If metric value is configured to more than 63, system throughs the following
warning:Warning: for metrics greater than 63, 'metric-style
wide' should be configured on level-1-2, or it will be
capped at 63.
If the metric style is WIDE, the metric values that are greater than 63 are only
effective.
level-1 (OPTIONAL) Enter the keywords level-1 to configure the shortest path first
(SPF) calculation for Level 1 (intra-area) routing. This setting is the default.
level-2 (OPTIONAL) Enter the keywords level-2 to configure the SPF calculation for
Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Dell Networking recommends configuring metrics on all interfaces. Without configuring this command, the
IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
C9000 Series
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Intermediate System to Intermediate System (IS-IS) 837