Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.11.1 Introduced on the Z9000.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.0 Introduced on the E-Series.

Commands

ip ssh server — enables the secure shell (SSH) server on the system.

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

C9000 Series

Syntax

ip telnet source-interface interface

To return to the default setting, use the no ip telnet source-interface [interface]

command.

Parameters

interface

Enter the following keywords and slot/port or number information:

● For Loopback interfaces, enter the keyword loopback then a number from

zero (0) to 16383.

● For a Port Channel, enter the keyword port-channel then a number. The

range is from 1 to 128.

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.

● For a tunnel interface, enter the keyword tunnel.

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.