Administrator Guide

maximum-paths
Configure the maximum number of equal cost paths allowed in a routing table.
C9000 Series
NOTE: You can use the maximum-paths command to configure a single system wide value that is common for both IPv4
and IPv6 addresses.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths an IP routing installs in a
routing table. The range is from 1 to 64. The default is 4.
Defaults 4
Command Modes
● ROUTER ISIS (for IPv4)
● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added support for multi-topology ISIS.
6.3.1.0 Introduced.
metric-style
Configure a router to generate and accept old-style, new-style, or both styles of type, length, and values (TLV).
C9000 Series
Syntax
metric-style {narrow [transition] | transition | wide [transition]}
[level-1 | level-2]
To return to the default values, use the no metric-style {narrow [transition] |
transition | wide [transition]} [level-1 | level-2] command.
Parameters
narrow Allows you to generate and accept old-style TLVs. The metric range is from 0 to
63.
Intermediate System to Intermediate System (IS-IS) 845