Administrator Guide
Parameters
connected Enter the keyword connected to redistribute active routes into IS-IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured routes into IS-IS.
metric
metric-
value
(OPTIONAL) Assign a value to the redistributed route. The range is from 0 to
16777215. The default is 0. Use a value that is consistent with the destination
protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the default route advertised
into a routing domain. Specify one of the following:
● external
● internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes.
This setting is the default.
route-map
map-
name
(OPTIONAL) If you do not enter the route-map argument, all routes are
redistributed. If a map-name value is not specified, no routes are imported.
Defaults
● metric metric-value = 0
● metric-type= internal; level-2
Command Modes
● ROUTER ISIS (for IPv4)
● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage
Information
To redistribute a default route (0.0.0.0/0), configure the default-information originate
command.
Changing or disabling a keyword in this command does not affect the state of the other command
keywords.
When an LSP with an internal metric is received, the Dell Networking OS considers the route cost while
considering the advertised cost to reach the destination.
Redistributed routing information is filtered with the distribute-list out command to ensure that
the routes are properly passed to the receiving routing protocol.
How a metric value assigned to a redistributed route is advertised depends on how on the configuration
of the metric-style command. If the metric-style command is set for Narrow or Transition mode
and the metric value in the redistribute command is set to a number higher than 63, the metric value
advertised in LSPs is 63. If the metric-style command is set for Wide mode, the metric value in the
redistribute command is advertised.
Intermediate System to Intermediate System (IS-IS) 849