Administrator Guide

Example
(Address-
Family_IPv6)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
Dell(conf-router_isis-af_ipv6)# show conf
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
C9000 Series
Syntax
show isis database [level-1 | level-2] [local] [detail | summary] [system-
id][lspid][vrf vrf-name]
Parameters
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Detailed link-state database information of each LSP displays when
specified. If not specified, a summary displays.
summary (OPTIONAL) Summary of link-state database information displays when specified.
system-id (OPTIONAL) Display link-state database for system-id.
lspid (OPTIONAL) Display only the specified LSP.
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display IS-IS
link state database corresponding to that VRF.
NOTE: If you do not specify this option, the IS-IS link state database
corresponding to the default VRF are displayed.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added supported for VRF. Introduced on the S6000-ON.
9.5(0.1) Inroduced on the Z9500.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
Intermediate System to Intermediate System (IS-IS) 855