Administrator Guide

Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set
the access conditions for the designated line.
C9000 Series
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port. The console option
for the S-Series is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to configure a virtual terminal
line for Telnet sessions. The system supports 10 Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class — restricts the incoming connections to a particular IP address in an IP access control list
(ACL).
password — specifies a password for users on terminal lines.
86 Control and Monitoring