Administrator Guide

Version Description
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.7.1.0 Introduced on the E-Series.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups.
You may not use extended access lists with this command. When you configure a static SSM map and the
router cannot find any matching access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
ip igmp static-group
Configure an IGMP static group.
C9000 Series
Syntax
ip igmp static-group {group address [exclude [source address]] | [include
{source address}]}
To delete a static address, use the no ip igmp static-group {group address [exclude
[source address]] | [include {source address}]} command.
Parameters
group address Enter the group address in dotted decimal format (A.B.C.D).
exclude source
address
(OPTIONAL) Enter the keyword exclude then the source address, in dotted
decimal format (A.B.C.D), for which a static entry is added.
include source
address
(OPTIONAL) Enter the keyword include then the source address, in dotted
decimal format (A.B.C.D), for which a static entry is added.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Expanded to support the exclude and include options.
Usage
Information
A group in include mode must have at least one source address defined. In exclude mode, if you do
not specify a source address, The system implicitly assumes all sources are included. If you do not specify
either include or exclude, the system implicitly assumes a IGMPv2 static join.
Command Limitations
876 Internet Group Management Protocol (IGMP)