Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage
Information
Retries are 20 seconds apart.
Related
Commands
show arp retries — displays the configured number of ARP retries.
arp timeout
Set the time interval for an ARP entry to remain in the ARP cache.
C9000 Series
Syntax
arp timeout minutes
Parameters
minutes Enter the number of minutes. The range is from 0 to 35790. The default is 4 hours
(240 minutes).
Defaults 240 minutes (4 hours)
Command Modes
● INTERFACE
● INTERFACE PORT EXTENDER (conf-if-pegi-pe-id/ stack-unit / port-id)
● INTERFACE (BATCH MODE)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
show interfaces — displays the ARP timeout value for all available interfaces.
904 IPv4 Routing