Administrator Guide

debug ip packet
View a log of IP packets sent and received.
C9000 Series
Syntax
debug ip packet [access-group name] [count value] [interface]
To disable debugging, use the no debug ip packet [access-group name] [count value]
[interface] command.
Parameters
access-group
name
Enter the keyword access-group then the access list name (maximum 16
characters) to limit the debug output based on the defined rules in the ACL.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1
to 65534. The default is Infinity.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For the Management interface, enter the keyword ManagementEthernet
then the slot/port information. The slot range is from 0 to 1 and the port range
is 0.
● For a Port Channel interface, enter the keywords port-channel then a
number. For the C-Series and S-Series, the range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the pe-id / stack-unit / port-id information.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Added the access-group option.
IPv4 Routing 913