Administrator Guide

distance (OPTIONAL) Enter the value of the distance metric assigned to the route. The
range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route must not be
removed even if the interface assigned to that route goes down. The route must be
currently active to be installed in the routing table. If you disable the interface, the
route is removed from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the route. The
range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use this VRF option
after the next hop to specify which VRF the next hop belongs to. This setting is
used in route leaking cases. Refer to the Route Leaking VRFs section in the Virtual
Routing and Forwarding (VRF) chapter of the Configuration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination address
and not for the route pointing to destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.14(1.2) Added the keyword name for static routes.
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON.
9.7(0.1) Introduced on the S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Included the weighted parameter to support weighted ECMP feature.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
IPv4 Routing 925