Administrator Guide

Example (Private
VLAN)
NOTE: In this example, Line 1 shows community VLAN 200 (in primary VLAN 10) in a PVLAN. Line 2
shows primary VLAN 10.
Dell#show arp
Protocol Address Age(min) Hardware Address Interface VLAN CPU
---------------------------------------------------------------
Internet 5.5.5.1 - 00:01:e8:43:96:5e - Vl 10 pv 200 CP
Internet 5.5.5.10 - 00:01:e8:44:99:55 - Vl 10 CP
Internet 10.1.2.4 1 00:01:e8:d5:9e:e2 Ma 0/0 - CP
Internet 10.10.10.4 1 00:01:e8:d5:9e:e2 Ma 0/0 - CP
Internet 10.16.127.53 1 00:01:e8:d5:9e:e2 Ma 0/0 - CP
Internet 10.16.134.254 20 00:01:e8:d5:9e:e2 Ma 0/0 - CP
Internet 133.33.33.4 1 00:01:e8:d5:9e:e2 Ma 0/0 - CP
Usage
Information
The following describes the show arp summary command shown in the following example.
Field Description
Total Entries Lists the total number of ARP entries in the ARP table.
Static Entries Lists the total number of configured or static ARP entries.
Dynamic Entries Lists the total number of learned or dynamic ARP entries.
CPU Lists which CPU the entries are stored on.
Example
(Summary)
#show arp summary
TotalEntries Static Entries Dynamic Entries CPU
----------------------------------------------
83 0 83 CP
Dell
Related
Commands
● ip local-proxy-arp — enables/disables Layer 3 communication in secondary VLANs.
● switchport mode private-vlan — sets PVLAN mode of the selected port.
show arp retries
Display the configured number of ARP retries.
C9000 Series
Syntax
show arp retries
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced.
IPv4 Routing 933