Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
931932933934935936937938939940
src-port
number
Enter the keywords src-port then the source port number.
destination-port
number
Enter the keywords destination-port then the destination port number.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This information is useful in identifying
which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this
command for routed packed only. For switched packets, use the show port-channel-flow
command.
The show ip flow command does not compute the egress port information when load-balance
mac hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol tcp
source-port 7898 destination-port 8
flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976
Ingress interface:Te 1/20
Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented packet
Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented packet
show ip interface
View IP-related information on all interfaces.
C9000 Series
Syntax
show ip interface [interface | brief] [linecard slot-id] [configured]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
938 IPv4 Routing