Administrator Guide

reload
Reboot the system.
C9000 Series
Syntax
reload [conditional nvram-cfg-change | pe pe-id]
From a PE console, use reload to perform a cold restart.
Parameters
conditional
nvram-cfg-
change
Reload if the condition is true. A configuration change to the nvram requires a
switch reload. To reload the switch, select nvram-cfg-change.
pe Reload the RMP, PE unit, or the entire PE stack configured under that PE unit.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If there is a change in the configuration, the system prompts you to save the new configuration. Or you
can save your running configuration with the copy running-config command. Use the conditional
parameter if any configuration changes made to the nvram, such as stack-group and fanout
configurations, must be saved.
To halt a port extender (PE) or an entire PE stack, and perform a cold-restart (from a PE console), use
the reload command.
send
Send messages to one or all terminal line users.
C9000 Series
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword console to send a message to the primary terminal line.
94 Control and Monitoring