Administrator Guide

cam-acl-egress
Allocate space for IPv6 egress ACLs.
C9000 Series
Syntax
cam-acl-egress {default | l2acl 1-3 ipv4acl 1-3 ipv6acl 0-2}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
● L2 ACL(l2acl): 1
● L3 ACL (ipv4acl: 1
● IPv6 L3 ACL (ipv6acl): 2
l2acl 1-3 ipv4acl
1- 3 ipv6acl 0-2
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the
CAM profile name then the allocation amount. The ipv6acl range must be a
factor of 2.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.2.0 Introduced on the E-Series TeraScale.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start), then reload the system.
You can use the cam-acl-egress command in Configuration Terminal Batch mode to allocate space for
egress ACLs in a dual-homing setup.
Example
Dell#
Dell#configure
Dell(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)#cam-acl-egress l2acl ?
<1-3> Number of FP blocks for l2acl
Dell(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-2> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
956 IPv6 Access Control Lists (IPv6 ACLs)