Administrator Guide

Version Description
9.2(0.0) Introduced.
Usage
Information
This command allows you to create an EUI64 address based on the specified prefix and MAC address
only. Prefixes may be configured on the interface using the ipv6 nd prefix command without
creating an EUI64 address.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets generated and sent in one second.
C9000 Series
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit
command.
Parameters
pps Enter the maximum number of error packets generated per second. The range is
from 1 to 200.
Default 100 pps
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
C9000 Series
Syntax
ipv6 flowlabel-zero
To remove 0 from the flow label field and allow the protocol operations to fill the field, use the no ipv6
flowlabel-zero command.
980 IPv6 Basics