Administrator Guide

● For a tunnel interface, enter the keyword tunnel then the tunnel ID.
● For a VLAN interface, enter the keyword VLAN.
● For a port channel interface, enter the keywords port-channel.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line
card. The range of slot IDs is from 0 to 2.
brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured interfaces.
managementethe
rnet slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the slot number
(0-1) and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitethern
et
(OPTIONAL) View information for an IPv6 tengigabitethernet interface.
fortyGigE (OPTIONAL) View information for an IPv6 fortygigabitethernet interface.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.11(0.0) Updated the command output to include the unicast reverse path forwarding
(uRPF) status.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Added support for IPv6 recursive DNS addresses.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
994 IPv6 Basics