Administrator Guide

Table 135. VRRP on VRF (continued)
Task Command Syntax Command Mode
virtual-address 10.1.1.100
no shutdown
View VRRP command
output for the VRF vrf1
show vrrp vrf vrf1
------------------
TenGigabitEthernet 0/13, IPv4 VRID:
10, Version: 2, Net: 10.1.1.1
VRF: 2 vrf1
State: Master, Priority: 100,
Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE,
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv
sent: 43, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Configuring Management VRF
You can assign a management interface to a management VRF.
1. Create a management VRF.
CONFIGURATION
ip vrf management
2. Assign a management port to a management VRF.
VRF MODE
interface management
When Management VRF is configured, the following interface range or interface group commands are disabled:
● ipv6 nd dad — Duplicated Address Detection
● ipv6 nd dns-server — Configure DNS distribution option in RA packets originated by the router
● ipv6 nd hop-limit — Set hop limit advertised in RA and used in IPv6 data packets originated by the router
● ipv6 nd managed-config-flag — Hosts should use DHCP for address config
● ipv6 nd max-ra-interval — Set IPv6 Max Router Advertisement Interval
● ipv6 nd mtu — Configure MTU advertisements in RA packets
● ipv6 nd other-config-flag — Hosts should use DHCP for non-address config
● ipv6 nd prefix — Configure IPv6 Routing Prefix Advertisement
● ipv6 nd ra-guard — Configure IPv6 ra-guard
● ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
● ipv6 nd reachable-time — Set advertised reachability time
● ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
● ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
● ipv6 ad <ipv6-address> — IPv6 Address Detection
● ipv6 ad autoconfig — IPv6 stateless auto-configuration
● ipv6 address <ipv6-address> — Configure IPv6 address on an interface
NOTE:
The command line help still displays relevant details corresponding to each of these commands. However, these
interface range or interface group commands are not supported when Management VRF is configured.
Virtual Routing and Forwarding (VRF) 1015