Administrator Guide

INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
● 1-Gigabit Ethernet: Enter gigabitethernet slot/port.
● 10-Gigabit Ethernet: Enter tengigabitethernet slot/port.
● 40-Gigabit Ethernet: Enter fortyGigE slot/port.
4. Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
5. To configure the VLT interconnect, repeat Steps 1–4 on the VLT peer switch.
6. Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
7. Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
The range is from 1 to 128.
8. (Optional) To configure a VLT LAG, enter the VLAN ID number of the VLAN where the VLT forwards packets received on
the VLTi from an adjacent peer that is down.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number peer-down-vlan vlan interface number
The range is from 1 to 4094.
Associating the VLT LAG or VLT VLAN in a PVLAN
1. Access INTERFACE mode for the port that you want to assign to a PVLAN.
CONFIGURATION mode
interface interface
2. Enable the port.
INTERFACE mode
no shutdown
3. Set the port in Layer 2 mode.
INTERFACE mode
switchport
4. Select the PVLAN mode.
INTERFACE mode
switchport mode private-vlan {host | promiscuous | trunk}
● host (isolated or community VLAN port)
● promiscuous (intra-VLAN communication port)
● trunk (inter-switch PVLAN hub port)
5. Access INTERFACE VLAN mode for the VLAN to which you want to assign the PVLAN interfaces.
CONFIGURATION mode
interface vlan vlan-id
6. Enable the VLAN.
INTERFACE VLAN mode
no shutdown
Virtual Link Trunking (VLT)
1057