Administrator Guide

Table 1. Command Modes (continued)
CLI Command Mode Prompt Access Command
Dell(conf-dcb-out)# (for output
policy)
DHCP
Dell(config-dhcp)# ip dhcp server
DHCP POOL
Dell(config-dhcp-pool-name)#
pool (DHCP Mode)
ECMP
Dell(conf-ecmp-group-ecmp-
group-id)#
ecmp-group
EIS
Dell(conf-mgmt-eis)# management egress-interface-
selection
FRRP
Dell(conf-frrp-ring-id)# protocol frrp
LLDP Dell(conf-lldp)# or Dell(conf-
if—interface-lldp)#
protocol lldp (CONFIGURATION or
INTERFACE Modes)
LLDP MANAGEMENT INTERFACE
Dell(conf-lldp-mgmtIf)#
management-interface (LLDP
Mode)
LINE Dell(config-line-console) or
Dell(config-line-vty)
line console orline vty
MONITOR SESSION
Dell(conf-mon-sess-
sessionID)#
monitor session
OPENFLOW INSTANCE
Dell(conf-of-instance-of-id)# openflow of-instance
PORT-EXTENDER CONFIGURATION
Dell(conf-pe-0)#
interface (INTERFACE modes)
PORT-CHANNEL FAILOVER-GROUP
Dell(conf-po-failover-grp)# port-channel failover-group
PRIORITY GROUP
Dell(conf-pg)# priority-group
PROTOCOL GVRP
Dell(config-gvrp)# protocol gvrp
QOS POLICY
Dell(conf-qos-policy-out-
ets)#
qos-policy-output
VLT DOMAIN
Dell(conf-vlt-domain)# vlt domain
VRRP
Dell(conf-if-interface-type-
slot/port-vrid-vrrp-group-
id)#
vrrp-group
UPLINK STATE GROUP
Dell(conf-uplink-state-group-
groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING
TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
The do Command
Use the do command to enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE,
SPANNING TREE, and so on.) without having to return to EXEC mode.
The following examples show how to use the do command in CONFIGURATION mode.
Dell#show ip interface brief
Configuration Fundamentals
37