Administrator Guide

INTERFACE mode
no shutdown
● The interface is the management interface.
INTEFACE mode
description
To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as shown in the
following example. To display the routing table, use the show ip route command in EXEC Privilege mode.
Dell#show int fortyGigE 2/12
fortyGigE 2/12 is up, line protocol is up
Hardware is DellEth, address is 74:86:7a:ff:6f:48
Current address is 74:86:7a:ff:6f:48
Pluggable media present, QSFP type is 40GBASE-CR4-1M
Interface index is 154288642
Internet address is 6.1.1.1/24
Mode of IPv4 Address Assignment : MANUAL
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
C 6.1.1.0/24 Direct, Fo 2/12 0/0 00:01:12
C 10.1.1.0/24 Direct, Vl 10 0/0 01:09:08
*S 0.0.0.0/0 via 6.1.1.1, Fo 2/12 0/0
00:01:12
Dell#
Port Extender Interfaces
You can use a C9010 switch with an attached C1048P, N20xx or N30xx port extender (PE) to expand the port density of the
chassis. In this configuration, the C9010 operates as a controlling bridge for the C1048P, N20xx or N30xx. The C1048P, N20xx
or N30xx functions as a remote line card that is physically connected to, and automatically provisioned by, a C9010 over 10GE
links according to the IEEE 802.1BR standard.
After the initial C1048P, N20xx or N30xx software provisioning is performed, you can configure L2 features on the port
extenders by entering CLI commands on a C9010. C1048P, N20xx or N30xx interfaces are identified in the command syntax:
interface peGigE pe-id/pe-stack—unit-id/port-number
● pe-id is a port-extender group ID number from 0 to 255.
● pe-stack-unit-id is a PE stack-unit number from 0 to 7.
● port-number is a port number from 1 to 48 (see Port Numbering).
interface peTenGigE pe-id/unit-number/port-id
● pe-id is a port-extender ID number from 0 to 255.
● unit-number is a PE stack-unit number from 0 to 7
424
Interfaces