Administrator Guide

● port-id is from 25 to 28 or 49 to 52 depending on the PE.
Dell(conf)#interface peGigE ?
PE-ID/UNIT/PORT PE Gigabit Ethernet interface number
Dell(conf)#interface peGigE 2/0/1
Dell(conf)#interface peTenGigE ?
PE-ID/UNIT/PORT PE TenGigabit Ethernet interface number
Dell(conf)#interface peTenGigE 21/0/49
For more information on how to configure and use port extenders with C9000 Series switches, see Port Extenders (PEs) and
Port Extender (PE) Stacking. If you use an N20xx or N30xx switch as a port extender, install Dell Networking OS 9.11(0.0) or
later. For more information about the conversion procedure, see the OS Conversion Guide for the N20xx/N30xx Series.
For information about how to install a PE and set up a PE stack, see the C1048P Getting Started Guide, C1048P Installation
Guide, N20xx/N30xx Getting Started Guide, and N20xx/N30xx Installation Guide.
VLAN Interfaces
VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of
VLANs. The supported VLAN range is 1 – 4094.
For more information about VLANs and Layer 2, refer to Layer 2 and Virtual LANs (VLANs).
NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based
internets: MIB-II (RFC 1213).
NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
The system supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in
routing protocols in the same manner that physical interfaces are used. For more information about configuring different routing
protocols, refer to the chapters on the specific protocol.
A consideration for including VLANs in routing protocols is that you must configure the no shutdown command. (For routing
traffic to flow, you must enable the VLAN.)
NOTE:
You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to
the default VLAN, use the default vlan-id vlan-id command.
To assign an IP address to an interface, use the following command.
● Configure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
○ ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
○ secondary: the IP address is the interface’s backup IP address. You can configure up to eight secondary IP addresses.
interface Vlan 10
ip address 1.1.1.2/24
tagged TenGigabitEthernet 2/2-13
tagged TenGigabitEthernet 5/0
ip ospf authentication-key force10
ip ospf cost 1
ip ospf dead-interval 60
ip ospf hello-interval 15
no shutdown
!
Interfaces
425