Administrator Guide
● Power Value — Dell Networking advertises the maximum amount of power that can be supplied on the port. By default the
power is 15.4W, which corresponds to a power value of 130, based on the TIA-1057 specification. You can advertise a
different power value using the max-milliwatts option with the power inline command. Dell Networking also honors
the power value (power requirement) the powered device sends when the PE is configured with power inline mode
class.
Figure 81. Extended Power via MDI TLV
Configure LLDP
Configuring LLDP is a two-step process.
1. Enable LLDP globally.
2. Advertise TLVs out of an interface.
Related Configuration Tasks
● Viewing the LLDP Configuration
● Viewing Information Advertised by Adjacent LLDP Agents
● Configuring LLDPDU Intervals
● Configuring Transmit and Receive Mode
● Configuring a Time to Live
● Debugging LLDP
Important Points to Remember
● LLDP is enabled by default.
● Dell Networking systems support up to eight neighbors per interface.
● Dell Networking systems support a maximum of 8000 total neighbors per system. If the number of interfaces multiplied by
eight exceeds the maximum, the system does not configure more than 8000.
● INTERFACE level configurations override all CONFIGURATION level configurations.
● LLDP is not hitless.
LLDP Compatibility
● Spanning tree and force10 ring protocol “blocked” ports allow LLDPDUs.
● 802.1X controlled ports do not allow LLDPDUs until the connected device is authenticated.
CONFIGURATION versus INTERFACE Configurations
All LLDP configuration commands are available in PROTOCOL LLDP mode, which is a sub-mode of the CONFIGURATION mode
and INTERFACE mode.
● Configurations made at the CONFIGURATION level are global; that is, they affect all interfaces on the system.
● Configurations made at the INTERFACE level affect only the specific interface; they override CONFIGURATION level
configurations.
Link Layer Discovery Protocol (LLDP)
551