Administrator Guide

Track IPv4 and IPv6 Routes
You can create an object that tracks an IPv4 or IPv6 route entry in the routing table.
Specify a tracked route by its IPv4 or IPv6 address and prefix-length. Optionally specify a tracked route by a virtual routing and
forwarding (VRF) instance name if the tracked route is part of a VRF. The next-hop address is not part of the definition of the
tracked object.
A tracked route matches a route in the routing table only if the exact address and prefix length match an entry in the routing
table. For example, when configured as a tracked route, 10.0.0.0/24 does not match the routing table entry 10.0.0.0/8. If no
route-table entry has the exact address and prefix length, the tracked route is considered to be DOWN.
In addition to the entry of a route in the routing table, you can configure how the status of a route is tracked in either the
following ways:
● By the reachability of the route's next-hop router.
● By comparing the UP or DOWN threshold for a route’s metric with current entries in the route table.
Track a Metric Threshold
If you configure a metric threshold to track a route, the UP/DOWN state of the tracked route is determined by the current
metric for the route entered in the routing table.
To provide a common tracking interface for different clients, route metrics are scaled in the range from 0 to 255, where 0 is
connected and 255 is inaccessible. The scaled metric value communicated to a client always considers a lower value to have
priority over a higher value. The resulting scaled value is compared against the threshold values to determine the state of a
tracked route as follows:
● If the scaled metric for a route entry is less than or equal to the UP threshold, the state of a route is UP.
● If the scaled metric for a route is greater than or equal to the DOWN threshold or the route is not entered in the routing
table, the state of a route is DOWN.
The UP and DOWN thresholds are user-configurable for each tracked route. The default UP threshold is 254; the default DOWN
threshold is 255. The notification of a change in the state of a tracked object is sent when a metric value crosses a configured
threshold.
The tracking process uses a protocol-specific resolution value to convert the actual metric in the routing table to a scaled metric
in the range from 0 to 255. The resolution value is user-configurable and calculates the scaled metric by dividing a route's cost
by the resolution value set for the route type:
● For intermediate system to intermediate system (ISIS), you can set the resolution in the range from 1 to 1000, where the
default is 10.
● For OSPF, you can set the resolution in the range from 1 to 1592, where the default is 1.
● The resolution value used to map static routes is not configurable. By default, Dell Networking OS assigns a metric of 0 to
static routes.
● The resolution value used to map router information protocol (RIP) routes is not configurable. The RIP hop-count is
automatically multiplied by 16 to scale it; a RIP metric of 16 (unreachable) scales to 256, which considers the route to be
DOWN. For example, to configure object tracking for a RIP route to be considered UP only if the RIP hop count is less than
or equal to 4, you would configure the UP threshold to be 64 (4 x 16) and the DOWN threshold to be 65.
Tracking a Metric Threshold
Use the following commands to configure object tracking on the metric threshold of an IPv4 or IPv6 route.
To remove object tracking, use the no track object-id command.
1. (Optional) Reconfigure the default resolution value used by the specified protocol to scale the metric for IPv4 or IPv6
routes.
CONFIGURATION mode
track resolution {ip route | ipv6 route} {isis resolution-value | ospf resolution-value}
The range of resolution values is:
● ISIS routes - 1 to 1000. The default is 1.
● OSPF routes - 1 to 1592. The efault is 1.
630
Object Tracking