Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
71727374757677787980
Configuring FTP Client Parameters
To configure FTP client parameters, use the following commands.
● Specify an FTP interface source.
CONFIGURATION mode
ip ftp source-interface interface
Enter the following keywords and slot/port or number information:
○ For a loopback interface, enter the keyword loopback then a number between 0 and 16383.
○ For a port channel interface, enter the keywords port-channel then a number from 1 to 255.
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● Configure a password.
CONFIGURATION mode
ip ftp password password
● Enter a username to use on the FTP client.
CONFIGURATION mode
ip ftp username name
To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode, as shown in the
example for Enable FTP Server.
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles.
Terminal lines on the system provide different means of accessing the system. The console line (console) connects you through
the console port. The virtual terminal lines (VTYs) connect you through a remote session to the system.
Denying and Permitting Access to a Terminal Line
Dell Networking recommends applying only standard access control lists (ACLs) to deny and permit access to VTY lines.
● Layer 3 ACLs deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny
traffic.
● You cannot use the show ip accounting access-list command to display the contents of an ACL that is applied
only to a VTY line.
To apply an IP ACL to a line, Use the following command.
● Apply an ACL to a VTY line.
LINE mode
ip access-class access-list
To view the configuration, use the show config command in LINE mode.
Dell(config-std-nacl)#show config
!
ip access-list standard myvtyacl
seq 5 permit host 10.11.0.1
Dell(config-std-nacl)#line vty 0
Dell(config-line-vty)#show config
line vty 0
access-class myvtyacl
Switch Management
71