Administrator Guide

The following example shows the show configuration output:
Dell(conf-pe-2)# show config
!
pe provision 2
stack-unit 1 type C1048P
stack-unit 1 access-ports 1
stack-unit 3 type N2024P-PE
cascade interface TenGigabitEthernet 1/2
The following example shows the show interfaces petenGigE 2/1/49 output:
DellEMC#show interfaces petenGigE 2/1/49
peTenGigE 2/1/49 is down, line protocol is down
Hardware is DellEMCEth, address is 00:00:00:00:00:00
Current address is 00:00:00:00:00:00
Pluggable media not present
No transmit power
Interface index is 558915592
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :000000000000
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:00:00
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:14:41
Reverting the Access Port to Uplink Port
You can revert the configured access port back to uplink port.
Use no stack-unit unit-number access-ports port-range command to revert the access port back to uplink
port.
After executing the above command, following message appears:
Dell(conf-pe-2)#no stack-unit 1 access-ports 1
Dell(conf-pe-2)#Oct 16 06:37:04 %RPM1-P:CP %IFMGR-5-ACCESSPORT_DELETED: PEX
port(peTenGigE 2/1/49) has been converted to an uplink port
Locating the Port Extender
● Use the location-led command to locate a PE by toggling its LED off and on.
EXEC Privilege mode
location-led pe pe-id stack-unit unit-number
740
Port Extender (PE) Stacking