Administrator Guide

Dell(conf-if-pegi-255/0/1)#power inline ?
<440-30000> Max milliwatts (default = 30000)
priority Configure poe priority
Dell(conf-if-pegi-0/0/1)#power inline 30000
Example of Setting the Priority to Critical
The following example sets the priority on interface peGigE 255/0/1 to critical.
Dell(conf-if-pegi-255/0/1)#power inline
Dell(conf-if-pegi-255/0/1)#power inline priority ?
critical Critical priority
high High priority
low Low priority (default)
Dell(conf-if-pegi-0/0/1)#power inline priority critical
Example of Displaying PoE Power Allocation on a Port Extender
The following example displays the PoE power allocation to power devices by the port extender, using the show power
inline {pe pe—id stack-unit unit-number | interface interface} command. For a description of the
fields, see Displaying PoE Power Allocation. For information about displaying inline power consumption on a port extender, see
Displaying Power Consumption on the Port Extender.
Dell#show power inline pe 255 stack-unit 0
Global inline power Threshold : 99
Power Reserved for inline Power: 1612W
Total Inline Power Consumed: 21W
Remaining inline power Available: 1580W
Power Management Mode: Class
Interface Inline Power Inline Power Class Device PoE Port LLDP
Max / Alloc Consumed Type Priority Support
(Watts) (Watts)
------------- ------------ ------------ ------- ------ -------- ------
PeGi 255/0/1 30.00/21.40 21.50 4 2 low 0
Example of Configuring Port Extender Interfaces with a Maximum Power of 15000 and 5000 mW
The following example sets the maximum allocated power to 15000 mW on interface peGigE 0/0/1 and 5000 mW on
interface peGigE 0/0/2 interface peGigE 0/0/3 is not configured. The default value of 30000 mW is the maximum power
that you can allocate to a device.
This configuration has the following PoE topology:
Power over Ethernet (PoE)
759