Administrator Guide

Pluggable media not present
Interface index is 804258823
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb00aa12
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode auto
Auto-mdix enabled, ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 20:06:07
Queueing strategy: fifo
Input Statistics:
10760802379 packets, 688691353132 bytes
10760802177 64-byte pkts, 203 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
203 Multicasts, 0 Broadcasts, 10760802177 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
2285 packets, 146240 bytes, 0 underruns
2285 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
1983 Multicasts, 0 Broadcasts, 302 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 76.00 Mbits/sec, 149280 packets/sec, 10.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 03:21:48
Configuring dot1x Profile
You can configure a dot1x profile for defining a list of trusted supplicant MAC addresses. A maximum of 10 dot1x profiles can be
configured. The profile name length is limited to 32 characters. Thedot1x profile {profile-name} command sets the
dot1x profile mode and you can enter profile-related commands, such as the mac command.
To configure a dot1x profile, use the following commands.
● Configure a dot1x profile.
CONFIGURATION mode
dot1x profile {profile-name}
profile—name — Enter the dot1x profile name. The profile name length is limited to 32 characters.
Dell(conf)#dot1x profile test
Dell(conf-dot1x-profile)#
Dell#show dot1x profile
802.1x profile information
-----------------------------
Dot1x Profile test
Profile MACs
00:00:00:00:01:11
Configuring MAC addresses for a do1x Profile
To configure a list of MAC addresses for a dot1x profile, use the mac command. You can configure 1 to 6 MAC addresses.
● Configure a list of MAC addresses for a dot1x profile.
DOT1X PROFILE CONFIG (conf-dot1x-profile)
mac mac-address
mac-address — Enter the keyword mac and type up to the 48– bit MAC addresses using the nn:nn:nn:nn:nn:nn format. A
maximum of 6 MAC addresses are allowed.
802.1X
89