Administrator Guide

Displaying Show sFlow Global
To view sFlow statistics, use the following command.
● Display sFlow configuration information and statistics.
EXEC mode
show sflow
The first bold line indicates sFlow is globally enabled. The second bold lines indicate sFlow is enabled on linecards Te 1/16 and Te
1/17.
Dell#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
Linecard 1 Port set 0 H/W sampling rate 8192
Te 1/16: configured rate 8192, actual rate 8192, sub-sampling rate 1
Te 1/17: configured rate 16384, actual rate 16384, sub-sampling rate 2
Displaying Show sFlow on an Interface
To view sFlow information on a specific interface, use the following command.
● Display sFlow configuration information and statistics on a specific interface.
EXEC mode
show sflow interface interface-name
The following example shows the show sflow interface command.
Dell#show sflow interface tengigabitethernet 1/16
Te 1/16
Configured sampling rate :8192
Actual sampling rate :8192
Sub-sampling rate :2
Counter polling interval :15
Samples rcvd from h/w :33
Samples dropped for sub-sampling :6
The following example shows the show running-config interface command.
Dell#show running-config interface tengigabitethernet 1/16
!
interface TenGigabitEthernet 1/16
no ip address
mtu 9252
ip mtu 9234
switchport
sflow enable
sflow sample-rate 8192
no shutdown
Displaying Show sFlow on a Line Card
To view sFlow statistics on a specified line card, use the following command.
● Display sFlow configuration information and statistics on the specified interface.
EXEC mode
904
sFlow