Administrator Guide

NOTE: A threshold level of 0 disables Syslog and SNMP traps.
● Configure the high or low CPU utilization threshold for SNMP traps.
CONFIGURATION mode
util-threshold cpu 5sec {cp | rp | lp | pe| all}
Dell(conf)#no util-threshold cpu 5sec ?
all All processors in the system
cp Control Processor
lp Linecard Processor
pe Port extender
rp Route Processor
Dell(conf)# util-threshold cpu 5 sec cp high 50
Dell#show util-threshold cpu
Processor 5Sec 1Min 5Min
High Low High Low High Low
=========================================================
Processor 5Sec 1Min 5Min
High Low High Low High Low
=========================================================
CP 50 50 85 75 80 70
RP 0 0 85 75 80 70
LP 0 0 0 85 75 80 70
LP 1 0 0 85 75 80 70
LP 2 0 0 85 75 80 70
LP 3 0 0 85 75 80 70
LP 4 0 0 85 75 80 70
LP 5 0 0 85 75 80 70
LP 6 0 0 85 75 80 70
LP 7 0 0 85 75 80 70
LP 8 0 0 85 75 80 70
LP 9 0 0 85 75 80 70
LP 10 0 0 85 75 80 70
LP 11 0 0 85 75 80 70
PE 0 0 85 75 80 70
Configuring Threshold Memory Utilization for SNMP
Traps
When the total memory utilization for a CPU exceeds the configured high/low threshold for a given time, a threshold
notification is sent as an SNMP trap. If a low threshold value is not specified, the low threshold value is set to the same value as
the high threshold value. Use the util-threshold memory command to configure the high or low memory utilization
threshold for SNMP traps.
Use the util-threshold memory command to configure the high or low memory utilization threshold for SNMP traps. Use
the show util-threshold memory to display the configured values of memory utilization thresholds.
Parameters
● cp — Enter the keyword cp to configure the memory utilization threshold for the Control Processor CPU.
● rp — Enter the keyword rp to configure the memory utilization threshold time for the Route Processor CPU
● lp — Enter the keyword lp to configure the linecard processor memory utilization threshold time. The range of switch slot
IDs is from 0 to 2.
● pe — Enter the keyword, pe to configure the CPU memory utilization time for of all PEs that are configured in the system.
● all — Enter the keyword all to configure the memory utilization threshold on all switch CPUs: Control Processor, Route
Processor, PE, and line cards.
● {{high | low} cpu-utilization-threshold-percentage} — Enter a percentage value to configure the high or low threshold level
for the percentage of memory a switch CPU can used. The percentage of CPU use ranges from 0 to 100.
914
Simple Network Management Protocol (SNMP)