Users Guide
To view a route reector conguration, use the show config command in CONFIGURATION ROUTER BGP mode or the show
running-config bgp in EXEC Privilege mode.
Aggregating Routes
The system provides multiple ways to aggregate routes in the BGP routing table. At least one specic route of the aggregate must be in the
routing table for the congured aggregate to become active.
To aggregate routes, use the following command.
AS_SET includes AS_PATH and community information from the routes included in the aggregated route.
• Assign the IP address and mask of the prex to be aggregated.
CONFIG-ROUTER-BGP mode
aggregate-address ip-address mask [advertise-map map-name] [as-set] [attribute-map map-name]
[summary-only] [suppress-map map-name]
Example of Viewing Aggregated Routes
In the show ip bgp command, aggregates contain an ‘a’ in the rst column (shown in bold) and routes suppressed by the aggregate
contain an ‘s’ in the rst column.
Dell#show ip bgp
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal,
a - aggregate, c - confed-external, r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 7.0.0.0/29 10.114.8.33 0 0 18508 ?
*> 7.0.0.0/30 10.114.8.33 0 0 18508 ?
*
>a 9.0.0.0/8 192.0.0.0 32768 18508 701 {7018 2686 3786} ?
*> 9.2.0.0/16 10.114.8.33 0 18508 701 i
*> 9.141.128.0/24 10.114.8.33 0 18508 701 7018 2686 ?
Dell#
Conguring BGP Confederations
Another way to organize routers within an AS and reduce the mesh for IBGP peers is to congure BGP confederations.
As with route reectors, BGP confederations are recommended only for IBGP peering involving many IBGP peering sessions per router.
Basically, when you congure BGP confederations, you break the AS into smaller sub-AS, and to those outside your network, the
confederations appear as one AS. Within the confederation sub-AS, the IBGP neighbors are fully meshed and the MED, NEXT_HOP, and
LOCAL_PREF attributes are maintained between confederations.
To congure BGP confederations, use the following commands.
• Species the confederation ID.
CONFIG-ROUTER-BGP mode
bgp confederation identifier as-number
• as-number: from 0 to 65535 (2 Byte) or from 1 to 4294967295 (4 Byte).
• Species which confederation sub-AS are peers.
CONFIG-ROUTER-BGP mode
bgp confederation peers as-number [... as-number]
• as-number: from 0 to 65535 (2 Byte) or from 1 to 4294967295 (4 Byte).
All Confederation routers must be either 4 Byte or 2 Byte. You cannot have a mix of router ASN support.
212
Border Gateway Protocol IPv4 (BGPv4)