Users Guide
• Source address validation is not supported for VPLAG interfaces on VLT.
• Port Extender does not support DHCP server.
Prerequisites for DHCP Snooping
• DHCP Snooping should be enabled globally on both VLT peers.
• The same Remote ID string and Remote ID host name should be congured on both VLT peers.
• To enable DHCP Secondary subnet feature in VLT, ensure that the secondary IP address subnet is the same in both VLT peers.
• Apply similar dynamic ARP inspection and source address validation congurations on both VLT peers.
• If you want to use the clear ip dhcp snooping binding command, use it individually on VLT nodes.
• In a dual-homed setup, you cannot congure DHCP snooping using batch mode. You can congure DHCP snooping separately on each
VLT peer.
• In the event of snooping VLAN operation down or interface delete, the removal of snooping binding entries is not synchronized to the
VLT peer .
Enabling DHCP Snooping
To enable DHCP snooping, use the following commands.
1 Enable DHCP snooping globally.
CONFIGURATION mode
ip dhcp snooping
2 Specify ports connected to DHCP servers as trusted.
INTERFACE mode
ip dhcp snooping trust
3 Enable DHCP snooping on a VLAN.
CONFIGURATION mode
ip dhcp snooping vlan name
Adding a Static Entry in the Binding Table
To add a static entry in the binding table, use the following command.
• Add a static entry in the binding table.
EXEC mode
EXEC Privilege mode
ip dhcp snooping binding mac
Clearing the Binding Table
To clear the binding table, use the following command.
• Delete all of the entries in the binding table.
EXEC Privilege mode
clear ip dhcp snooping binding
350
Dynamic Host Conguration Protocol (DHCP)