Users Guide
no ip address
shutdown
!
interface TengigabitEthernet 9/7
no ip address
shutdown
!
interface TengigabitEthernet 9/8
no ip address
shutdown
!
interface TengigabitEthernet 9/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset any congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 893
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and congure the interfaces, enter INTERFACE mode by using the
interface interface {slot/port | pe-id/stack-unit/port} command.
1 Enter the keyword interface then the type of interface and slot/port information.
432
Interfaces