Users Guide

Figure 81. Conguring LLDP
Viewing the LLDP Conguration
To view the LLDP conguration, use the following command.
• Display the LLDP conguration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Congurations
The following example shows viewing an LLDP global conguration.
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
R1(conf-lldp)#
The following example shows viewing an LLDP interface conguration.
R1(conf-lldp)#exit
R1(conf)#interface tengigabitethernet 1/31
R1(conf-if-te-1/31)#show config
!
interface TengigabitEthernet 1/31
no ip address
switchport
no shutdown
R1(conf-if-te-1/31)#protocol lldp
R1(conf-if-te-1/31-lldp)#show config
!
protocol lldp
R1(conf-if-te-1/31-lldp)#
578
Link Layer Discovery Protocol (LLDP)