Users Guide
netadmin Exec Cong Interface Router IP Route-map Protocol MAC
secadmin Exec Cong Line
sysadmin Exec Cong Interface Line Router IP Route-map Protocol MAC
User Roles
This section describes how to create a new user role and congure command permissions and contains the following topics.
• Creating a New User Role
• Modifying Command Permissions for Roles
• Adding and Deleting Users from a Role
Creating a New User Role
Instead of using the system dened user roles, you can create a new user role that best matches your organization. When you create a new
user role, you can rst inherit permissions from one of the system dened roles. Otherwise you would have to create a user role’s command
permissions from scratch. You then restrict commands or add commands to that role. For more information about this topic, see Modifying
Command Permissions for Roles
.
NOTE: You can change user role permissions on system pre-dened user roles or user-dened user roles.
Important Points to Remember
Consider the following when creating a user role:
• Only the system administrator and user-dened roles inherited from the system administrator can create roles and user names. Only the
system administrator, security administrator, and roles inherited from these can use the "role" command to modify command
permissions. The security administrator and roles inherited by security administrator can only modify permissions for commands they
already have access to.
• Make sure you select the correct role you want to inherit.
• If you inherit a user role, you cannot modify or delete the inheritance. If you want to change or remove the inheritance, delete the user
role and create it again. If the user role is in use, you cannot delete the user role.
1 Create a new user role
CONFIGURATION mode
userrole name [inherit existing-role-name]
2 Verify that the new user role has inherited the security administrator permissions.
Dell(conf)#do show userroles
EXEC Privilege mode
3 After you create a user role, congure permissions for the new user role. See Modifying Command Permissions for Roles.
Example of Creating a User Role
The conguration in the following example creates a new user role, myrole, which inherits the security administrator (secadmin)
permissions.
Create a new user role, myrole and inherit security administrator permissions.
Dell(conf)#userrole myrole inherit secadmin
Security
867