Administrator Guide

Version Description
6.2.1.1 Introduced
ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
C9000 Series
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa {number}
command then the ip msdp cache-rejected-sa {number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range is from 0 to 32766.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Related
Commands
show ip msdp sa-cache rejected-sa
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
C9000 Series
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is specified, then all
SAs from the peer are accepted.
Defaults Not configured.
Command Modes CONFIGURATION
1026 Multicast Source Discovery Protocol (MSDP)