Administrator Guide

• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Example
(Statistics)
Dell#show ip ospf 100 statistics
Interface TenGigabitEthernet 0/8
Hello-Timer 9, Wait-Timer 0, Grace-Timer 0
Error packets (Only for RX)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unkown-Pkt 0
Neighbor ID 9.1.1.2
Hello DDiscr LSReq LSUpd LSAck
RX 59 3 1 1 1
TX 62 2 1 0 0
Dead-Timer 37, Transmit-Timer 0
LSU-Q-Len 0, LSU-Q-Wmark 0
LSR-Q-Len 0, LSR-Q-Wmark 1
Related
Commands
clear ip ospf statistics — clears the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
C9000 Series
Syntax
show ip ospf [process-id|vrf vrf-name]timers rate-limit
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
vrf vrf-name Enter the keyword vrf and the name of the VRF to view LSAs corresponding to a
specific VRF that are currently in queue waiting for timers to expire.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.4(0.0) Added support for VRF on all platforms (Except MXL and STOMP).
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
1134 Open Shortest Path First (OSPFv2 and OSPFv3)