Administrator Guide
PE Console Commands
To configure a C1048P port extender from an attached PE console, you can use the following commands. Use these commands when the
port extender cannot connect to a C9010.
You can also enter the PE console commands to debug an error condition in a PE stack.
• cd
• clear logging
• copy
• delete
• diag
• dir
• disable
• enable
• exit
• format
• hostname
• offline
• online
• power-cycle
• pwd
• reload
• rename
• reset
• show boot system
• show clock
• show control-bridge status
• show diag
• show diag information
• show diag testcase
• show environment
• show file
• show file-systems
• show interfaces
• show inventory
• show lldp neighbors
• show logging
• show logging driverlog
• show logging kernellog
• show os-version
• show privilege
• show redundancy
• show revision
• show system
• show tech-support
• show version
• telnet-peer-stack-unit
For information about the commands you can enter from a C9010 console to configure a port extender, see Port Extenders (PE) chapter.
Topics:
• diag
39
PE Console Commands 1171