Administrator Guide

Slot number range is from 0 to 9. In linecard slots 0 to 9, the range of port numbers is
from 0 to 23.
peer Enter peer to configure the VLT peer in a dual-homing setup. This parameter is available
only in the Configuration Terminal Batch Mode.
Default None
Command Modes
PE CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode and the peer parameter on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
This command provisions the port extender for automatic link aggregation group (LAG) port channel creation on
the connected ports. The LAG member ports must be operationally up and have a default port configuration with
no Layer 2 and Layer 3 configuration. The port interfaces must be of the same type. You can configure up to 16
switch ports in the auto-LAG.
Use cascade interface interface slot/port-range peer in the Configuration Terminal Batch
Mode to provision the port extender in a dual-homing setup. It is recommended to configure the port extender
through batch mode only in a dual-homing setup. If the peer is not connected during the configuration, ensure
that you import the configuration from the peer once it is up. See import peer-config.
• The slot/port-range specifies a line card and either a single port number, a port range, or a combination of
both for auto-LAG configuration. The range of slot numbers is from 0 to 9 for linecard slots. The range of port
numbers is from 0 to 23.
Example
PE Configuration Mode
Dell(conf)# feature extended-bridge
Dell(conf)# pe provision 4
Dell(conf-pe-4)#cascade interface tengigabitethernet 1/1-2
Configuration Terminal Batch Mode
Dell#conf terminal batch
Peer is registered
Dell(conf-b)#pe provision 4
Dell(conf-b-pe-4)#cascade interface tengigabitethernet 1/1-2
clear pe statistics
Delete the statistics related to a specified port extender.
C9000 Series
Syntax
clear pe pe-id statistics
Parameters
pe-id Enter the keyword pe and the port extender ID. Range is from 0 to 255.
statistics Enter the keyword statistics to delete the statistics related to a specified PE from
the system.
Port Extenders (PE) 1247