Administrator Guide

Default
None
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
When the location LED setting is turned “on” for a port extender (PE), the main power supply LED on the PE
flashes green light and when the location LED setting is turned ”off”, the main power supply LED is in a solid green
state.
Thelocation-led settings are not saved through power cycles if the C1048 system is power cycled.
Example
Dell#
Dell#location-led pe 255 stack-unit 0 on
pe
Add a pre-provisioned port extender (PE) .
C9000 Series
Syntax
pe pe-id
To remove a port extender, use the no pe pe-id command.
Parameters
pe pe-id Enter keyword pe and PE ID. The range is from 0 to 255.
Default None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The pe pe-id command adds a pre-provisioned PE. The port extender ID (pe-id) range is from 0 to 255. You
can add a port extender stack-unit using stack-unit unit number keyword.
To remove a port extender, use the no pe pe-id command.
Example
Entering pe context
DELL(conf)# pe 0
Removing pe 0
DELL(conf)# no pe 0
Entering port extender configuration mode:
DELL(conf)#pe 10
DELL(conf-pe-10)#
1250 Port Extenders (PE)