Administrator Guide

DELL(conf-pe-10)#stack-unit 0 type c1048P
Related
Commands
• stack-unit – add or delete a specified port extender stack-unit.
• show pe —display the port extender status and details.
pe provision
Logically provision or add a port extender (PE).
C9000 Series
Syntax
pe provision pe-id
To de-provision or delete a port extender, use the no pe provision pe-id command.
Parameters
pe provision pe-id Enter port-extender configuration mode to logically provision a port extender. Port
extender ID range is from 0 to 255
Default None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(2.0P2) Introduced the PE description and stack-unit description options.
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
Before you provision a port extender, enable the extended bridge feature using the feature extended—
bridge command. The pe provision pe-id command logically pre-provisions or adds a port extender (PE)
even when the PE is not physically connected to the switch. The port extender ID (pe-id) range is from 0 to 255.
After provisioning a PE using the pe provision pe-id , you can provision a stack unit using the stack-
unit command.
You can also add a PE description and stack-unit description using the description name and the stack-
unit 0 description name commands respectively.
You can provision a port extender connected in a Dual-Homing setup from the Configuration Terminal Batch
mode.
To de-provision a port extender, use the no pe provision pe-id command.
NOTE: You must ensure that the port extender units are offline before you issue the no pe
provision command.
Example
DELL(conf)# pe provision 10
DELL(conf-pe-10)#
DELL(conf)# no pe provision 10
DELL(conf)# pe provision 0
DELL(conf-pe-0)# stack-unit 0 type N2048-PE
DELL(conf-pe-0)# stack-unit 1 type N2024P-PE
Port Extenders (PE) 1251