Administrator Guide

Example
Dell#show pe errors
PE-id: Not Assigned
PE MAC: f8:b1:56:00:01:04
Interface Errors:
TenGigabitEthernet 1/16 - Error State
Dell#show pe 9
Codes: A - Active, I - Inactive
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present,
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - Card Validation Error
PE-ID assigned: 9
Status: online
System Mac: f8:b1:56:00:01:28
PE Up Time: 08:36:56
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 1/9(A),Te 1/16(I)
Cascade LAG: Po 267(Up)
----------------------------------------------------------------------
Stack-id Status Reason Type UnitMac No. of Ports
---------------------------------------------------------------------
0 online - C1048P f8:b1:56:00:02:24 52
1 online - C1048P f8:b1:56:00:01:28 52
2 online - C1048P f8:b1:56:00:01:90 52
3 online - C1048P 00:00:ab:00:00:2c 52
Dual Homing
Use the commands in the following section to setup the configurations on a port extender connected in a dual-homing environment.
commit
Use commit to apply the common configurations made in the Configuration Terminal Batch mode.
C9000 Series
Syntax
commit
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in
a dual-homing environment. Use the commit command to apply the configuration changes. In the Configuration
Terminal Batch mode, you can continue to commit the changes without exiting the batch mode.
Example Example with multiple Commits:
Dell#configure terminal batch
Peer is registered
Dell(conf-b)#interface peGigE 184/0/1
Dell(conf-b-if-pegi-184/0/1)#no shutdown
Dell(conf-b-if-pegi-184/0/1)#commit
Dell(conf-b)#Apr 5 06:48:28: %RPM1-P:CP %CLIBATCH-6-
1258 Port Extenders (PE)