Administrator Guide

When the advertise med power-via-mdi command is enabled in CONFIGURATION mode, advertisement
is enabled for all the interfaces in a system. To enable advertisement for a specific interface, configure the
command in INTERFACE configuration mode.
Port extender (PE) processes and advertises LLDP power-via-MDI TLVs when the LLDP advertisement of the
TLV is enabled on the PE in class power management mode. Incoming LLDP messages are processed only when
the PE is in class power management mode.
on-disable
Enable transmission of LLDP shutdown frames.
C9000 Series
Syntax
on-disable transmit {shutdown}
Parameters
transmit Enter the keyword transmit to transmits the LLDP frames.
shutdown Enter the keyword shutdown to shut down the LLDP frames.
Defaults None.
Command Modes CONFIGURATION INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The on-disable transmit shutdown command allows transmission of LLDP shutdown frames when the
LLDP protocol is disabled in the interface mode.
Example
Dell#sh running-config interface tengigabitethernet 0/1
!
interface TenGigabitEthernet 10/1
no ip address
switchport
switchport mode private-vlan host
!
protocol lldp
on-disable transmit shutdown
no shutdown
Related
Commands
show running-config lldp — displays the LLDP running configuration.
power budget global-threshold
Set a global threshold limit for the PoE power budget on a specified port extender.
C9000 Series
Syntax
power budget global-threshold pe pe-id stack-unit unit number threshold-value
Parameters
pe pe-id Enter the keyword pe and port extender ID. Range is from 0 to 255.
stack-unit unit
number
Enter the keyword stack-unit and unit number. Range is from 0 to 7.
1276 Port Extenders (PE)