Administrator Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show monitor session 1
SessID Source Destination Dir Mode SourceIP DestIP DSCP TTL Drop Rate Gre-
Protocol FcMonitor
----- ------ ----------- --- ---- -------- ------- ---- --- --- ----
------------ ---------
1 PeGi 0/0/0 Te 10/2 rx Port 0.0.0.0 0.0.0 0 0 0 No N/A N/
A Yes
Related
Commands
monitor session — creates a monitoring session.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
C9000 Series
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show running-config monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range from 0 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Port Monitoring 1289