Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1291

Defaults none

Command Modes INTERFACE VLAN

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the C-Series and S-Series.

Usage Information The VLAN:

• can be in only one mode, either community, isolated, or primary.

• mode ode to community or isolated even before associating it to a primary VLAN. This secondary VLAN

continues to work normally as a normal VLAN even though it is not associated to a primary VLAN. (A syslog

message shows this information.)

• must not have a port in it when VLAN mode is being set.

Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk ports (as previously described)

can be added to the PVLAN. No other regular ports can be added to the PVLAN.

After using this command to configure a VLAN as a primary VLAN, use the private-vlan mapping

secondary-vlan command to map secondary VLANs to this VLAN.

Commands

• private-vlan mapping secondary-vlan — maps secondary VLANs to the selected primary VLAN.

• show interfaces private-vlan — displays the type and status of the PVLAN interfaces.

• show vlan private-vlan — displays the PVLANs and/or interfaces that are part of a PVLAN.

• switchport mode private-vlan — sets PVLAN mode of the selected port.

private-vlan mapping secondary-vlan

Map secondary VLANs to the selected primary VLAN.

C9000 Series

Syntax

[no] private-vlan mapping secondary-vlan vlan-list

To remove specific secondary VLANs from the configuration, use the no private-vlan mapping

secondary-vlan vlan-list command syntax.

Parameters

vlan-list

Enter the list of secondary VLANs to associate with the selected primary VLAN. The list

can be in comma-delimited or hyphenated-range format, following the convention for the

range input.