Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1321

Defaults Layer 3

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 E-Series Only: Expanded to add support for Layer 2.

6.1.1.1 Introduced on the E-Series.

Usage Information You can attach a single policy-map to one or more interfaces to specify the service-policy for those interfaces. A

policy map attached to an interface can be modified.

NOTE: The service-policy commands are not allowed on a port channel. The service-policy

input policy-map-name command and the service-class dynamic dot1p command are

not allowed simultaneously on an interface. However, the service-policy input command

(without the policy-map-name option) and the service-class dynamic dot1p command are

allowed on an interface.

Commands

policy-map-input — creates an input policy map.

service-policy output

Apply an output policy map to the selected interface.

C9000 Series

Syntax

service-policy output policy-map-name

To remove the output policy map from the interface, use the no service-policy output policy-map-

name command.

Parameters

policy-map-name

Enter the name for the policy map in character format (32 characters maximum). You can

identify an existing policy map or name one that does not yet exist.

Defaults none