Administrator Guide

Parameters
number Enter the alarm integer number from 1 to 65535. The value must be unique in the RMON
alarm table.
variable Enter the MIB object to monitor. The variable must be in the SNMP OID format; for
example, 1.3.6.1.2.1.1.3. The object type must be a 32-bit integer.
interval Time, in seconds, the alarm monitors the MIB variables; this is the alarmSampleType in the
RMON alarm table. The range is from 5 to 3600 seconds.
delta Enter the keyword delta to test the change between MIB variables. This is the
alarmSampleType in the RMON alarm table.
absolute Enter the keyword absolute to test each MIB variable directly. This is the
alarmSampleType in the RMON alarm table.
rising-threshold
value event-
number
Enter the keywords rising-threshold then the value (32 bit) the rising-threshold
alarm is either triggered or reset. Then enter the event-number to trigger when the rising
threshold exceeds its limit. This value is the same as the alarmRisingEventIndex or
alarmTable of the RMON MIB. If there is no corresponding rising-threshold event, the
value is zero.
falling-threshold
value event-
number
Enter the keywords falling-threshold then the value (32 bit) the falling-threshold
alarm is either triggered or reset. Then enter the event-number to trigger when the falling
threshold exceeds its limit. This value is the same as the alarmFallingEventIndex or the
alarmTable of the RMON MIB. If there is no corresponding falling-threshold event, the
value is zero.
owner string (OPTIONAL) Enter the keyword owner then the owner name to specify an owner for the
alarm. This is the alarmOwner object in the alarmTable of the RMON MIB.
Defaults owner
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
rmon collection history
Enable the RMON MIB history group of statistics collection on an interface.
C9000 Series
Syntax
rmon collection history {controlEntry integer} [owner name] [buckets number]
[interval seconds]
To remove a specified RMON history group of statistics collection, use the no rmon collection history
{controlEntry integer} command.
1358 Remote Monitoring (RMON)