Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.29.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
distribute-list out
Configure a filter for outgoing routing updates.
C9000 Series
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | ospf |
static]
To delete the filter, use the no distribute-list prefix-list-name out command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only directly connected routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured routes.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Routing Information Protocol (RIP) 1375