Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1421

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

tacacs-server host

Specify a TACACS+ host.

C9000 Series

Syntax

tacacs-server host {hostname | ipv4-address | ipv6-address} [port number]

[timeout seconds] [key key]

Parameters

hostname

Enter the name of the TACACS+ server host.

ipv4-address

ipv6-address

Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the TACACS+ server

host.

port

number

(OPTIONAL) Enter the keyword port then a number as the port to be used by the

TACACS+ server. The range is from zero (0) to 65535. The default is 49.

timeout

seconds

(OPTIONAL) Enter the keyword timeout then the number of seconds the switch waits

for a reply from the TACACS+ server. The range is from 0 to 1000. The default is 10

seconds.

key

(OPTIONAL) Enter the keyword key then a string up to 42 characters long as the

authentication key. This authentication key must match the key specified in the tacacs-

server key for the TACACS+ daemon.

Defaults Not configured.