Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1461

count

value

Enter the keyword count then the number of debug outputs. The range is from 1 to 100.

Defaults Debug disabled.

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.

7.4.1.0 Introduced

protocol-tunnel

Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.

C9000 Series

Syntax

protocol-tunnel {rate-limit rate| stp}

To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel command.

Parameters

rate-limit

rate

Enter the keyword rate-limit followed by a number for the rate-limit for tunneled

packets on the VMAN. The range is from 64 to 320.

stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including STP,

MSTP, RSTP, and PVST.

Defaults none

Command Modes CONF-IF-VLAN

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.